|
The Nor-Vise is normally provided with “Small In-Line Jaws” and includes a matching Thread Post, Mounting Bolts, Operating and Set-up instructions, Allan Wrench, and a hour long professionally produced instructional video.
Centerline Concept
The Nor-Vise Concept is to position the hook on the centerline of rotation and then turn the hook rather than wrap hand over hand around the hook. A thread post, aligned with the center of rotation, permits material to be “turned” or “spun” onto the hook without the the tying thread being wrapped on at the same time.
Precision ball bearing and heavy brass hubs enable the Nor-Vise to work like a spinning wheel for dubbing like you have never seen before. Perfectly shaped and textured bodies, with all dubbing material, can be created, without wax better, faster and much easier than by any other method.
The Nor-Vise system will accommodate a variety of jaw designs that can be quickly and easily mounted onto the vise arbor. Although all four of the different configurations handle nearly any fly tying situation, from very tiny and delicate trout flies to large saltwater patterns, these different designs each excel in certain applications.
Note:
If you have an older version of the Nor-Vise with an integral Front Hub/Arbor is is still possible to change from one design to another. Order your conversion to include a new arbor. To change from one configuration to another remove the black “O” ring and the Rear Hub will slide off, remove the drive disc and the entire Front Hub/Arbor assembly will slide out of the ball bearings. Replace it with the new conversion and it is ready to go. You can also send in your older vise to have your front hub modified, add a friction clamp and in general up grade your old Nor-Vise to be like a new one.
|
 |
